Repairs for the things that stop working.
Aghdyta Electricals is a small repair workshop in Nagpur. Fans, mixers, pumps and motors, and the cooling side of the trade — air coolers, water coolers and small air conditioners. Everything is run on the bench before it goes back.
What comes into the workshop
-
Fans & regulators
Ceiling, table and exhaust fans, and the regulators they are wired through.
-
Mixers & small appliances
Mixers, grinders and the small motors inside them, usually a winding or a brush.
-
Pumps & motors
Monoblock and submersible pumps, rewound or re-bushed as they need.
-
Coolers & air conditioners
Air coolers, water coolers, and split and window air conditioners.
At the bench
Most of what arrives is one of a few faults: a burnt winding, a dry bearing, a failed capacitor, or a cooling coil that has furred up. We open the appliance, find which of those it is, and tell you before any part is replaced.
Small motors are rewound in the workshop. Sealed compressor units are not something we open, and we will say so rather than take on a machine that needs one.
- Windings rewound and varnished
- Bearings and bushes replaced
- Capacitors, switches and regulators
- Cooling pads, tanks and coils cleaned
How a job runs
-
Tell us what it is doing
Email the appliance, what it does now, and roughly how old it is.
-
We look at it
It is opened and tested on the bench, and the fault is found before anything is ordered.
-
You hear the cost
You are told what needs replacing and what it comes to. Nothing is ordered until you agree.
-
Repaired and run again
The part is fitted, the appliance is run, and you are told what the fault was.
Send us a message
A short description is enough to start with. Say what the appliance is, what it does now, and how old it is if you know.
Nagpur, Maharashtra · Monday to Saturday, 10am – 7pm